Resistor Pack Nissan Micra
To fix it, you can either replace the entire pack, or, in some cases, have the individual resistors changed. Liamautomechanic 29,813 views 10:34 Nissan 200sx blower motor repair and resistor - Duration: 5:51. Do you think it is a resistor or new motor that I need. Community Links User Tagging Statistics Hash Tag Subscriptions iTrader Search Forums Show Threads Show Posts Advanced Search Google Search Find All Thanked Posts Go to Page...
Resistor Pack Nissan Micra
Don't know if this is abit to much trouble for some but it saved me probably 400$ at the garage. If you remove the card, you just need to desolder the (which should be deteriorated) resistor/joint on one of the rails (its the only one on the card) and then cut Remove the old resister.
should by 50W min. Once you've done that, scrape a fraction of the coating off the rail (VERY carefully as the rails come off the card very easily) and then hold the paper clip in Loading... Nissan Micra K12 Blower Motor Replacement I carefully pried the motor out of the casing.
No, create an account now. Nissan Micra K12 Heater Motor Removal Nissan Forums 240sx / Silvia Maxima / I30 / I35 350Z / 370z Altima / Bluebird Sentra Versa GTR / Skyline Juke Leaf Cube Murano Quest Rogue Pathfinder Frontier / Xterra Today 10:47 AM by Blue Devil 9 1 Attachment(s) cell phone mount - 2013... https://www.micra.org.uk/threads/micra-k12-heater-not-blowing.53273/ Sean LonePhantom »CMF Member CanberraAustralia Member since: Posts: Re: Heater fan not working Thu 01 May 2008 09:56:10 PM Is it safe with a paper clip?
First time? Nissan Micra Heater Not Blowing Email Address: OR Log-in User Name Password Remember Me? Click here to ask a question. Perhaps just a blown fuse?
Nissan Micra K12 Heater Motor Removal
Remove the connector, then remove the 2 phillips screws holding the resistor in place, then remove the resistor itself by pulling it downwards. http://forums.digitalspy.co.uk/showthread.php?t=1404198 I have EXACTLY the same problem (also 52 micra), except that I still have settings 3 and 4 working. Resistor Pack Nissan Micra Took the fan motor apart. Nissan Micra Heater Blower Motor We found out today that the clutch cable had come lose and the clip had gone that holds it in place.
Nothing. http://noipc.org/nissan-micra/nissan-micra-key-problem.html Watch QueueQueueWatch QueueQueue Remove allDisconnect Loading... This usually has 3 resistors for settings 1, 2 and 3, with setting 4 being a direct connection. Laiwah Manh 359,264 views 4:24 coolant flush/fill - Duration: 5:39. Micra K12 Heater Blower Removal
I was abit worried I'd never get it back together but at that point I figured I was screwed and would have to buy a new motor So I carried on Loading... I swapped that out and BAM had function on 1-4. http://noipc.org/nissan-micra/nissan-micra-key-programming.html The fan may have died.
up vote 3 down vote favorite I've got a Nissan Micra E 03 reg & the problem is my fan doesn't work on settings 1 & 2 but does work on Nissan Micra K12 Blower Faults Both my wife and I drive... Any ideas?
Bushings for the motor shaft looked pretty nasty.
The heater in my car is only working on one setting (most powerful). So far it has been quiet. Today 10:48 AM by 4x4CHRIS 341 6 Attachment(s) Todd!!! Micra K11 Heater Resistor Card first the dealership tech had tapped the back of the blower motor housing and it had unstuck it, but they did order me a new motor for the warranty claim.
The question: nissan micra heater blower problem ? I wondered if I bought the motor from say ebay, how hard it would be to fit myself? The brushes were work but still quite a bit of life left. Dragonfly »CMF Member HartlepoolUnited Kingdom Member since: Posts: K12 Heater blower not working on any setting .
I'm thinking it's either a break/short in the wiring harness or I got a defective resistor. All rights reserved. I really will need to get this fan working and I'm about to give up.