Home > Water Heater > Electric Water Heater No Hot Water

Electric Water Heater No Hot Water

Contents

ReviewsWATER HEATERSElectric Water HeatersNatural Gas Water HeatersLiquid Propane Water HeatersLearn More (Gas)6th Sense™Cost of OperationHow Gas Water Heaters WorkBasic Product FeaturesModel Numbers GuideFAQsGlossaryLearn More (Electric)Standard Electric Water Heaters6th Sense™ Water HeatersCost Hope that helps. -- Larry Q1: This problem seems similar to mine. (GE electric heater, 3 years old) A few days ago, the hot water suddenly started out coming out scalding I also changed from well water to county water and installed a pressure valve in line with my main line. I recently had the water heater (rental) company service man out to replace the rod in my electric water heater, as the hot water was discolored. http://noipc.org/water-heater/electric-water-heater-reset-button.html

Remember Me? Not having a thermal expansion tank is the most common reason for a dripping discharge pipe. Sign in to add this to Watch Later Add to Loading playlists... Not having a thermal expansion tank is the most common reason for a dripping discharge pipe. http://www.whirlpoolwaterheaters.com/owner-center/installation-video-guides/electric-installation-videos-guides/troubleshooting-repair/

Electric Water Heater No Hot Water

Turn the circuit breaker off, replace the plastic cover, insulation and access panel. If it won’t unscrew, use a cold chisel and hammer to loosen the threads.

Photo 5: Install the new element Thread the new element into the water heater and tighten If you own and understand a volt-ohm meter, you can test with it instead. The same thing has happened with me resetting the red button, the breaker tripping , etc.

where your power comes in at the upper thermostat, read from line to line. To minimize corrosive minerals through ionization, water heaters have a magnesium or aluminum anode rod, inserted through the top of the tank. I recommend if it's too bad to contact the city you live in and the water department. How To Tell If Electric Water Heater Is Working Repeat the test on the second terminal.

Are there scorch marks or signs of water? My Water Heater Is Not Heating Water Any idea where I can find a better thermostat that will fit? Testing Thermostat for Power with Voltmeter If the unit is powered with the correct voltage, and still does not produce any hot water, the upper heating element has probably burned out. http://www.doityourself.com/forum/water-heaters/343419-installed-new-electric-water-heater-not-working.html Advertise Find a Contractor Interactive How-to's About Us Terms of Use Privacy Policy Cookie Policy Site Map DoItYourself.com is an INTERNET BRANDS company.

Subscribe To Our Newsletter!Join our mailing list to receive the latest news and updates from the HomeTipsteam. No Hot Water How To Fix Of course the other (non-thermostat) side of each element is always hot. -- David A7 : You say a normal fast-acting 30 amp fuse blows in 3-4 minutes. One time I put in a breaker fuse and it blew a couple times and I kept resetting it. If something less than that is being used, that right there is a problem.

My Water Heater Is Not Heating Water

All other trademarks are owned by their respective companies. © 2014Whirlpool Corporation. read review It is extremely rare for a new tank to leak. "Electric Thermal Expansion Tank" View The Printable Guide (PDF) "Thermal Expansion Tank" Water Drips If drips are noticed coming from the Electric Water Heater No Hot Water Please don't do the work yourself if you're not conversant with 240 VAC. Water Heater Reset Button I checked the braker it is good.

A little bit of darkened insulation of a wire is not the end of the world, but charred insulation needs addressing (replace the wire or reinsulate in a code-approved manner) AND weblink Working... Explosion Hazard. Any and all advice/suggestions would be so greatly appreciated!!! Gas Water Heater Not Working

steven lavimoniere 155,300 views 34:34 Loading more suggestions... It worked perfectly up until recently. So... http://noipc.org/water-heater/rinnai-tankless-water-heater-troubleshooting-no-hot-water.html For one thing, the words "hot" and "cold", and possibly "T&P valve" words would be upside down, plus ALL water heaters have the cold inlet on the right side, REGARDLESS of

The top thermostat sends power to either the top element or the bottom thermostat. Electric Water Heater Thermostat I don't know if I've had this problem since I've moved in, or if its rescent. When the water on the top of the tank is hot, the top element turns off and the lower one heats.

Do you think water got on the burner and ruined it, or should I wait a little longer ?

If not, then you have a problem before the heater. Loading... If the problem is only with the hot water, in most cases the odor is caused by a reaction between the hot water heater’s anode rod and water that has a Hot Water Heater Circuit Breaker I don't know how smart it may be.

Interestingly, a time delay 30 amp fuse does not blow, just gets very hot. Turn down the water heater’s temperature and allow the water to cool, then replace the water heater's pressure relief valve. I've heard that these Apcom thermastats stink ( and my experience has proved it). his comment is here Can someone please give me advise on what to do to fix this problem Don Vandervort, HomeTips Sounds to me like a defective pressure relief valve, but I'd like to have

You did set the temp on the t-stat? If steam or excessively hot water shoots out of faucets, or you hear boiling sounds inside the water heater, the appliance may not be shutting off at its set temperature. Turn the circuit breaker off, replace the plastic cover, insulation and access panel. Don Vandervort, HomeTips Make sure there isn't a valve partially closed either coming or going from the water heater.

Typical water heater problems include a leaking tank (see Water Heater Is Leaking), not enough hot water, water that is too hot or not hot enough, strange noises in the tank,